Installing The Copilot Receiver For Motors Manufactured 2017 Or After - MINN KOTA COPILOT Manuel Du Propriétaire

INSTALLATION
9
p. Using a #2 Phillips Screwdriver, replace the two
Screws to secure the Right Sideplate to the
Mount.

Installing the CoPilot Receiver for Motors Manufactured 2017 or After

NOTE: Please verify the year your motor was manufactured before beginning. See page 6 for details.
1
a. Make sure that the Power Cables from the
battery are disconnected, or that the breaker,
if equipped, is "off".
WARNING
Make sure the motor is mounted on a secure, level surface
and is not connected to a power source.
2
b. Using a #2 Phillips Screwdriver, remove the two
Screws from the Right Sideplate that secure it to
the Mount.
c. Remove the Right Sideplate.
2c
10 | minnkotamotors.com
2b
Right Sideplate
Sideplate Screw
Power Cables
Sideplate Screw
©2016 Johnson Outdoors Marine Electronics, Inc.