Service & Maintenance; Troubleshooting; For Further Troubleshooting And Repair - MINN KOTA COPILOT Manuel Du Propriétaire

SERVICE & maIntEnanCE

TROUBLESHOOTING

Cause
Remote is not transmitting.
When receiver is powered up, it
sounds a beep pattern (1 long
beep, 2 short beeps, pause,
repeat).
The prop is not turning but the
Prop ON audio pattern is still
going.

FOR FURTHER TROUBLESHOOTING AND REPAIR

We offer several options to help you troubleshoot and/or repair your product. Please read through the options listed below.
Buy Parts Online
You can buy parts on-line directly from our website at minnkotamotors.com. Orders confirmed by 12 noon central time will
ship same day if in stock. Orders after 12 noon central time will ship the next business day if in stock.
Frequently Asked Questions
We have FAQs available on our website to help answer all of your Minn Kota questions. Visit
click on "Frequently Asked Questions" to find an answer to your question.
Call Us (for U.S. and Canada)
Our consumer service representatives are available Monday – Friday between 7:00 a.m. – 4:30 p.m. CST at 800-227-
6433. If you are calling to order parts, please have the 11-character serial number from your product, specific part numbers,
and credit card information available. This will help expedite your call and allow us to provide you with the best consumer
service possible. You can reference the parts list located in your manual to identify the specific part numbers.
Email Us
You can email our consumer service department with questions regarding your Minn Kota products.
To email your question, visit
Authorized Service Centers
Minn Kota has over 300 authorized service centers in the United States and Canada where you can
purchase parts or get your products repaired. Please visit our Authorized Service Center page on
our website to locate a service center in your area.
©2016 Johnson Outdoors Marine Electronics, Inc.
Effect
The battery is discharged.
Receiver may not have "learned" the remote.
With the foot pedal connected, the MOM-CON
switch is in the CON position. An audio response will
be heard if a button is pressed with the foot pedal in
the CON position.
If remote has been taken apart, the keypad and top
case may have been installed backwards.
The foot pedal Momentary/Constant Switch is in the
CON position.
Prop Speed is set at "0".
The Prop ON audio pattern occurs only in Audio
Mode 3
minnkotamotors.com and click on "Support".
Solution
Replace battery.
Remote needs to be learned. See the Adding/
Removing Remotes section of this manual to learn
the remote.
The foot pedal switch must be placed in Momentary
Mode (MOM). The receiver will not accept any
commands from the remote with the switch in the
Constant Mode (CON) position.
Take remote apart. See the Replacing the Battery
section of this manual and reinstall case halves with
the proper orientation.
The foot pedal switch must be placed in the MOM
position. The beeping sound will continue until the
switch is placed in the MOM position.
Increase the Prop Speed above "0"
Switch Audio Mode to either Audio 1 or 2. See the
Audio Modes section of this manual.
minnkotamotors.com and
Scan to visit
Minn Kota
service online.
minnkotamotors.com | 21