MINN KOTA COPILOT Manuel Du Propriétaire page 12

INSTALLATION
5
i. With the Right Sideplate laying flat, and the
CoPilot Receiver that was just installed facing
upwards, route the yellow wire Antenna through
the pegs and grooves on the Right Sideplate.
Follow the grooves in each of the pegs.
j. Route the CoPilot Power Connection through the
bottom groove in the Right Sideplate.
6
k. Remove the Dust Cap from the Connection Port
located towards the back end of the exposed side
of the motor on the right side of the Mount.
l. Take the CoPilot Power Connection that comes
off of the CoPilot Receiver that is attached to the
Right SidePlate and Plug it into the Connection
Port.
NOTE: Do not apply lubricant or any type of
grease to trolling motor connectors. Make sure
that the flat sides of the Power Connection and
Connection Port align so the plugs connect
together correctly.
7
m. Be sure that the CoPilot Power Connection sits
comfortable between the Mount and the Right
Sideplate and can not be pinched. Reseat the
Right Sideplate.
n. Using a #2 Phillips Screwdriver, replace the two
Screws from the Right Sideplate of the Terrova
mount.
7n
12 | minnkotamotors.com
Right Sideplate
Sideplate Screw
Right Sideplate
Antenna
6k
Connection Port
Dust Cap
7m
Power Connection
CoPilot Receiver
6l
Connection Port
Power Connection
Right Sideplate
©2016 Johnson Outdoors Marine Electronics, Inc.