MINN KOTA MICRO REMOTE Guide De Référence Rapide

Compatible with all Bluetooth
REMOTE
High Speed
Bypass
Decrease
Speed
Prop On/Off
Steer Left
NOTICE:
If your motor is connected to a Heading Sensor,
the Speed Down (backwards), Speed Up
Steer Right and Steer Left
Jog the boat while in Spot-Lock.
PAIRING
Pairing the Micro Remote to your
Controller
An i-Pilot controller may pair up to 5 remotes. These five remotes can
be a combination of standard i-Pilot remotes and Micro Remotes. Any
additional remotes can be paired using the following steps. Once the
maximum number of remotes have been paired, the controller will start
replacing the oldest paired remote in memory with the new remote.
1. Power up the trolling motor.
2. Locate the Pair button at the top of the Control Head.
PAIR
3. Push and hold the Pair
emitted from the Control Head.
NOTICE:
Make sure the remote stays within range of the
Control Head during the pairing process.
4. While holding the Pair
hold the High Speed Bypass
on the remote simultaneously.
©2018 Johnson Outdoors Marine Electronics, Inc.
® enabled i-Pilot ® Link TM and i-Pilot systems only.
Steer Right
(forward),
buttons function change to
button down. A consistent tone will be
PAIR
button on the Control Head, push and
PAIR
button and AutoPilot
MANUAL CONTROL BUTTONS
AutoPilot
Spot-Lock
Increase
Speed
NAVIGATION BUTTONS
NOTICE:
Controller, the High Speed Bypass
button need to be held down simultaneously. Make sure to also
hold the Pair
the remote to the controller.
5. Once successfully paired, 3 longer beeps will be emitted from the
Control Head and the remote will be paired.
NOTICE:
A controller can have multiple remotes paired to it.
button
MICRO REMOTE
QUICK REFERENCE GUIDE
Speed Down & Speed Up
Press to decrease or increase motor speed.
Prop On/Off
Pressing this button will turn the Prop on and off.
Steer Left & Steer Right
Press to steer the motor to the left or to the right.
High Speed Bypass
Bypasses the current motor speed to speed 10.
Double press to engage. Single press to disengage.
Spot-Lock
Press to enable Spot-Lock. When Spot-Lock is enabled
from the Micro Remote, use either the i-Pilot or i-Pilot
Link remote, or the fish finder if you want to save it.
AutoPilot
Press to enable AutoPilot. The selection between
Legacy AutoPilot and Advanced AutoPilot must be
made from either the i-Pilot or i-Pilot Link remote.
When the remote is being paired to the i-Pilot
button on the Control Head to successfully pair
PAIR
A remote can be paired to one controller at a time.
Scan to view the complete Micro Remote
Owner's Manual online. The Owner's Manual is
available at minnkotamotors.com
informaton on compatibility, safety considerations,
compliance, maintenance, parts and more.
button and the AutoPilot
and includes
minnkotamotors.com