MINN KOTA COPILOT Manuel Du Propriétaire page 11

3
ITEM(S) NEEDED
d. Turn the Right Sideplate over.
e. Take the CoPilot Receiver (Item #B) and position
it so that the Learn button is towards the bottom
right of the sideplate.
f. The Antenna and CoPilot Power Connection
should sit to the left and exit the board from the
surface that sits towards the Right Sideplate.
The CoPilot Received should sit towards the right
Screw Peg on the SidePlate.
4
ITEM(S) NEEDED
#4 x 1
g. Check the placement of the CoPilot Receiver by
making sure that the Learn Button is visible when
the Right Sideplate is turned over.
h. Using the #6-20 X 3/8'' Screw (Item #4)
provided, insert the screw through the Mounting
Hole in the CoPilot Receiver and into the Screw
Peg on the Right Sideplate. Be sure that
the wires are not pinched in the Screw Peg
when tightening the Screw using a #1 Phillips
Screwdriver. Do not over tighten.
NOTE: Do not over tighten the Screw that
holds the CoPilot Receiver in place.
©2016 Johnson Outdoors Marine Electronics, Inc.
#B x 1
Antenna
Power Connection
CoPilot Receiver
4g
4h
Screws
Learn Button
Power Connection
Antenna
CoPilot Receiver
INSTALLATION
Right Sideplate
Mounting Hole
Right Sideplate
Right Sideplate
minnkotamotors.com | 11