Replacing The Battery - MINN KOTA COPILOT Manuel Du Propriétaire

2
b. Press and hold the Learn Button and power up
the CoPilot receiver by reconnecting the Power
Cables, or by making sure that the breaker, if
equipped, is "on".
c. Continue to hold the Learn Button down for 10
seconds. During this time the receiver audio
will emit a warble sound, slowly transition to a
constant beep and then shut off.
d. Release the Learn Button and the receiver will
reboot. The receiver will emit a 2 second long
beep indicating memory is empty. This audio
pattern will occur each time the receiver powers
up until a remote is "Learned".

REPLACING THE BATTERY

1
a. Temporarily ground yourself by touching a
grounded metal object in order to discharge any
static electricity in your body.
NOTE:
The replacement battery must be a model
CR2032 coin cell type. It is strongly recommended
that a name brand battery is used.
b. Remove the four screws on the bottom of the
remote case.
c. Separate the case halves to access the circuit
board.
2
d. To remove the Battery, place the tip of a finger
or thumb under the exposed edge of the Battery
and pry it upwards.
e. Install the new battery with the positive (+) side
of the Battery facing up and away from the Circuit
Board. Ensure Battery is snapped securely in
place.
NOTE:
The replacement battery must be a model
CR2032 coin cell type. It is strongly recommended
that a name brand battery is used.
©2016 Johnson Outdoors Marine Electronics, Inc.
Right Sideplate
Learn Button
Remote
Case Front
Battery
COPILOT
Screws
Circuit Board
Retaining Fingers
minnkotamotors.com | 17