MINN KOTA COPILOT Manuel Du Propriétaire page 8

INSTALLATION
4
ITEM(S) NEEDED
#4 x 1
e. With the CoPilot Cover removed, take the CoPilot
Receiver (Item #B) and position it in the space
below where the CoPilot Cover was attached.
f. Position the CoPilot Receiver so that the Learn
Button is positioned towards the upper left of
the sideplate. The Antenna and CoPilot Power
Connection should sit to the right and exit the
board from the surface that sits towards the
Right Sideplate. The Mounting Hole in the
CoPilot Receiver should sit on the left Screw Peg
on the sideplate.
g. Check the placement of the CoPilot Receiver by
making sure that the Learn Button is visible when
the Right Sideplate is turned over.
h. Using the #6-20 X 3/8'' Screw (Item #4)
provided, insert the Screw through the receiver
and into the Right Sideplate. Be sure that
the wires are not pinched in the Screw Pegs
when tightening the Screw using a #1 Phillips
Screwdriver. Do not over tighten.
NOTE:
Do not over tighten the Screw that
holds the CoPilot Receiver in place.
5
i. With the Right Sideplate laying flat, and the
CoPilot Receiver that was just installed facing
upwards, route the yellow wire Antenna through
the pegs and grooves on the Right Sideplate.
Follow the grooves in each of the pegs.
j. Route the Power Connection through the bottom
groove in the Right Sideplate.
8 | minnkotamotors.com
#B x 1
4e
Mounting Hole
Screw
CoPilot Receiver
Power Connection
4g
Right Sideplate
4h
Screw
CoPilot Receiver
Right Sideplate
CoPilot Receiver
Screw Peg
Right Sideplate
Antenna
Learn Button
Antenna
Power Connection
Antenna
Power Connection
©2016 Johnson Outdoors Marine Electronics, Inc.