Copilot; Controlling The Motor With Copilot - MINN KOTA COPILOT Manuel Du Propriétaire

COPILOT

CONTROLLING THE MOTOR WITH COPILOT

Review the complete CoPilot section of this manual to become familiar with this feature. For more information on CoPilot or for
additional product support, please visit minnkotamotors.com.
High Speed Bypass
Decrease Speed
AutoPilot ON/OFF
Steer Left
Increase Speed
Prop ON/OFF
Steer Right
Prop ON/OFF
This button is located in the middle of the remote. It turns the propeller on or off. Press the button once to turn the propeller ON;
press button a second time to turn it OFF. The button does not need to be held down.
Steer Left & Steer Right
These buttons are located to the right and left of the Prop ON/OFF button and have an arrow symbol. They cause the motor to
turn in the desired direction as long as the button is held down. If the Steer Right or Steer Left button is held for more than seven
seconds, the steering will automatically stop until the button is pressed again.
Increase Speed & Decrease Speed
The Increase Speed and Decrease Speed buttons are located above the Prop ON/OFF button and are identified with a positive
and negative symbol. Pressing and releasing these buttons causes the speed to increase or decrease by increments of 1. The
speed is adjustable from level 0-10. At level 0, the prop will not turn.
In audio mode 2, an audible beep is heard for each increment when changing speed. Attempting to go higher than speed 10
or lower than speed 0 will result in the speed not changing and no beep will be heard. See the Audio Mode section for more
information.
If the receiver senses no foot pedal or remote operation for 1 hour, the remote speed setting is automatically set to zero. This
helps prevent unintentional activation of the propeller if the prop on/off remote button is inadvertently pressed.
Autopilot On/Off
The AutoPilot button is located on the top right side of the remote. It functions to turn AutoPilot on or off. The button does not
need to be held down. If the motor does not have AutoPilot, the AUTOPILOT ON/OFF button will be non-functional.
High Speed Bypass
The High Speed Bypass button is located on the top left side of the remote. It toggles the speed between the current speed
setting and the maximum speed setting (level 10). Pressing the button sets the motor at speed 10 instantly; pressing the button
again sets the motor speed back to the previous speed setting.
minnkotamotors.com | 13
©2016 Johnson Outdoors Marine Electronics, Inc.