Assembling The Roof Elements; Fitting The Interior Lindea Decor; Assembling The Sauna Benches; Mounting The Exterior Lindea Decor - Sentiotec LINDEA VIEW SMALL Mode D'emploi

Installation instructions, only for experts

3.4. Assembling the roof elements

Insert the roof elements and screw them to the cabin walls. Observe the cable
outlets.
Fit the roof cover strips on the outside.

3.5. Fitting the interior Lindea decor

Mount the interior decor elements with 8 screws each, starting at the side walls
W1 and W6.
When mounting the Lindea decor elements on the rear wall, make sure the
ventilation slot is correctly positioned and the distances to the sides are correct.
Mount the cover strip (633x40x40) over the glass.
Fit the Lindea decor roof elements. Make sure the cover for the sensor above
the heater is correctly positioned.

3.6. Assembling the sauna benches

Mount the support slats of the sauna bench with adjustable head piece on the side
walls so that the upper edge is 845 mm high and 50 mm from the rear wall. Before
mounting the sauna bench, drill the holes to guide cables for the LED through.
Mount the other bench support slats at a height of 355 mm.
Screw the benches to the bench support slats and the bench foot from below.

3.7. Mounting the exterior Lindea decor

Mount the exterior decor elements with 8 screws each, starting on the side walls
next to the glass elements.
Mount the exterior decor elements above the glass.

3.8. Installing the glass door

Screw the two door fittings onto the glass element, making sure that they are
straight and that the doors open outward.
The alignment of the fittings is achieved by adjusting / rotating both
plastic inserts.

3.9. Installing accessories

Mount the ventilation slide.
The door handles are screwed together from the inside.
Fit the door magnet and sleeve plate.
p. 13/32
EN