Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installations for instructions
3.3. Assembling the glass elements
Please note that when you install the glass element "glass with
holes for door hinges", you are defining the direction in which the door
opens. The hole at the bottom for the door hinge is located at a height
of 26.3 cm.
Place the U-shaped aluminium profile flush onto the glass elements, and insert
the glass elements into the groove provided on the corner post for this purpose.
Mount the strip over the glass and screw it diagonally to the corner post and the
cover strip.
3.4. Roof installation
Install the roof support slats and screw them to the wall elements.
Insert the roof elements and screw them to the roof support slats. Observe the
cable outlets.
Install the roof cover slats and the roof trim slats on the outside.
3.5. Installing interior fittings
Mount the ventilation slide.
Install the bench support slats.
Install the stainless steel foot on the upper bench.
Start by placing the lower bench on the bench support slats.
Secure the bench screen.
Put the upper benches in place, and screw them to each other.
Install the infrared radiator and the radiator cover.
Please observe the installation instructions included with the infrared
radiator! The connection box for the infrared radiator must be at the
top. The writing on the glass of the infrared radiator must be legible.
Install the backrests.
Install heater protection grill.
p. 11/12
EN
Publicité
Table des Matières
