Safety Notes; Important Notes; Functions; Spare Parts - LGB 199 031-6 Mogelin Manuel

Safety Notes

• This locomotive is to be used with the operating system
designed for it.
• Use only switched mode power supply units and transfor-
mers that are designed for your local power system.
• This model may only be supplied with power from a
suitable power generation source.
• Pay close attention to the safety notes in the instructions
for your operating system.
• Not for children under the age of 15.
• WARNING! Sharp edges and points required for operation.

Important Notes

• The operating instructions are a component part of the
product and must therefore be kept in a safe place as
well as included with the product, if the latter is given to
someone else.
• Please see your authorized LGB dealer for repairs or

spare parts.

• http://www.maerklin.com/en/imprint.html

Functions

• This model is designed for operation on LGB two-rail DC
systems with conventional LGB DC train controllers or
power packs (DC, 0 - 24 volts).
• Use a locomotive controller with more than 1 amp of train
current for this model.
8
Mode of Operation Switch
There is a 4-position mode of operation switch in the loco-
motive (Fig. 1).
Pos. 0 All power off
Pos. 1 Power to lights
Pos. 2 Power to lights and motors
Pos. 3 Same as Position 2
Multi-Purpose Socket
The model has a "flat" multi-purpose socket, with a remo-
vable cover, on the rear of the loco (Fig. 2). These sockets
can be used to provide track power to cars with lighting or
sound electronics. To remove the cover of the socket, pull it
straight out. If the cover is tight, gently use a small straight
screwdriver to pry it out. (Do not pull out the rectangular
outer housing).
Multi-Train System
The model is equipped with a factory-installed onboard de-
coder for the LGB Multi-Train System. It can be used without
modifications on analog or digital layouts. For operation
with the Multi-Train System, the model is programmed to
loco address 03. For information on programming the loco
address, see the instructions for various MTS components.
When operating with the Multi-Train System, you can remo-
tely control the loco's functions. Press the lighting button
("9" with remotes) to turn the loco lights on or off.
When operating with the Multi-Train System, the loco fea-
tures a "Back-EMF" function. This keeps the motor speed
constant (and under normal conditions the loco speed),
even when the load of the loco changes, for example, in
curves or on grades.