Install Anti-Tip Device - Monogram ZDP366NTSS Instructions D'installation

3

INSTALL ANTI-TIP DEVICE

To reduce the risk of tipping the range, the range must
be secured by a properly installed anti-tip bracket. See
installation instructions shipped with the bracket for
complete details before attempting to install.
To check if the bracket is installed and engaged
properly, look underneath the range. The anti-tip bracket
should be inserted into the opening on the anti-tip brace
on the range. If the bracket arm misses the brace to the
left or right, or the bracket arm is not protruding through
the brace opening, the bracket must be reinstalled.
If the range is pulled from the wall for any reason,
always repeat this procedure to verify the range is
properly secured by the anti-tip bracket.
If your range has no anti-tip bracket, call 1.800.626.8774
to receive one at no cost.
If the anti-tip device supplied with the range does not
fit this application, use the universal Anti-Tip Device
WB2X7909.
Read the AHAM Anti-Tip Safety Brochure packed with
the bracket.
Anti-Tip Parts Provided
4 Wood Screws
3 Hex Head Screws (2
required, 1 extra)
Anti-Tip Brace
12
Installation
WARNING
• A child or adult can tip the range and be killed.
• Install the anti-tip bracket to the wall or floor.
• Engage the range to the anti-tip bracket by sliding the
range back such that the foot is engaged.
• Re-engage the anti-tip bracket if the range is moved.
• Failure to do so can result in death or serious burns
to children or adults.
Anti-Tip Bracket
AHAM Anti-Tip
Safety Brochure
Tip-Over Hazard
■ A ttach the anti-tip brace onto the bottom of the range
in the recessed area. Install 2 hex screws (provided)
through the brace and into the range.
NOTE: This anti-tip device may be installed on the
opposite side of the range.
Alternate Brace
Position
■ M easure and mark Dimension A (see table below)
from the left (or right) side of the installation location.
If the countertop has an overhang, add that dimension
to Dimension A.
■ P lace the anti-tip bracket against the floor and back wall
at the marked location. Mark screw holes for fastening
the bracket to the wall sole plate and the floor.
■ D rill 1/8" pilot holes at a 20° angle.
■ S ecure the bracket to the wall and/or floor with at least
2 wood screws (provided).
For Concrete or Cement Construction: You must use
appropriate fastening hardware (not provided).
Range A
30" 5-1/16"
36" 5-1/16"
48" 8-1/4"
A
Hex Screws
Anti-Tip Brace
Anti-Tip Bracket
Wall Sole Plate
31-2000667 Rev. 1