Uxadbs36Pss, Uxadbs48Pss Accessory Installation; Accessories-30" To 36" Adjustable Backsplash; Tools And Materials Required; Install The Wall Support Panels - Monogram ZDP366NTSS Instructions D'installation

UXADBS36PSS, UXADBS48PSS Accessory Installation

ACCESSORIES—30" TO 36" ADJUSTABLE BACKSPLASH (not included)
■ T his backsplash adjusts to fit the space between
the top of the range and the bottom of the hood,
from 30" Min. to 36" Max. height.
■ M aximum shelf load-bearing weight is 40 lbs.

TOOLS AND MATERIALS REQUIRED

■ G loves to protect against sharp edges
■ T -15 and #2 Phillips screwdrivers
■ D rill with 3/32" and 9/64" bits
■ S afety glasses
Top Cover
■ L evel
with Shelf
■ P encil
This Kit Includes
■ T op wall support
■ B ottom wall support
■ T op cover with shelf
■ B ottom cover
■ H ardware package with
– 9 Stainless Steel Torx 15 #8
self-tapping screws
– 9 Phillips #2 pan head wood
#10 screws
– 3 Stainless Steel #2 truss head
#10 screws (for alternate
installation method)
20
Top Wall
Support
Bottom Cover
Bottom Wall Support
Hardware
Package
761Dia65

INSTALL THE WALL SUPPORT PANELS

WARNING
The wall support panels must be
securely fastened to the wall. Failure to do so could
result in damage or personal injury.
IMPORTANT: This backsplash is designed to cover
the wall between the bottom of the hood and the top of
the range. The vent hood should be installed over the
rangetop or range before installing this backsplash.
■ I nstall and level the Range/Rangetop according to
the product installation instructions.
■ R emove backsplash packaging and protective film.
■ L ocate wall studs on each side. Where studs are not
available, plan to use wall anchors (not provided).
■ U se a level to pencil 2 horizontal lines on the wall,
one 1/8" below the vent hood and the other 1/8"
above the Range/Rangetop. This 1/8" space allows
the cover panels to overlap the wall supports.
■ S ecure the top wall support panel to the wall with 4
wood screws, through the outermost studs.
■ U se 4 wood screws to secure the bottom wall support
panel. The center slot should be positioned at the top.
The gap between the top and bottom support panels
will be covered by the top cover with shelf.
1/8"
Center
Arrow
Wood
Screws
1/8"
Secure the
top panel to
the wall with 4
wood screws
Wood
Screws
Secure the
bottom panel to
the wall with 4
wood screws
31-2000667 Rev. 1