Kozy Heat Fireplaces KZK-054 Mode D'emploi page 18

3.2.3 CLW-ST Combustible Wall Finish
• Figure 3.9 shows installation of combustible wall finish up to 1"
thick. This combustible material goes over any required non-
combustible materials as shown in Figure 3.3 on page 15.
• This 1" (25mm) combustible material is able to go down to the
fireplace finishing edge.
• See Figure 3.6 on page 16 for up to 1" (25mm) thick
combustible material installation around the discharge trim of
the KZK air discharge opening.
Non-combustible zone
Combustible wall nish
up to 1" (25mm) thick
may be installed over
required non-combustible
material up to the top
nishing edge and the
bottom of the air
discharge opening
Finishing
edge
Non-combustible
material only
Figure 3.9, #KZK-054 Combustible Wall Finish for CLW-ST
18 FACING AND FINISHING
CLW-ST
17"
(432mm)
Combustible wall nish
up to 1" (25mm) thick
may be installed over
76"
required non-combustible
(1930mm)
material up to the top
bottom of the air
discharge opening
Finishing
edge
Non-combustible
material only
Fireplace enclosure oor
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
nishing edge and the
Komfort Zone Kit #KZK-054 R.5