Troubleshooting Guide; 14 7.6.1 Fault Log List; 14 7.7 Diagnostics And Indicators - Nice Ten TN2010 Instructions Et Recommandations Pour L'installateur

7.6) Troubleshooting guide

Table 18 provides some useful information to deal with any malfunc-
tions that may occur during installation, or in the event of faults.
Table 18: troubleshooting
Symptom
The radio transmitter does not control the door
and the transmitter led does not illuminate
The radio transmitter does not control the door
but transmitter led illuminates
...no manoeuvre is activated and the OK led
does not flash
...no manoeuvre is activated and the flashing
light is off
...the manoeuvre does not start and the courtesy
light flashes a few times
The manoeuvre starts but immediately afterwards
a brief inversion is activated
7.6.1) Fault log list
TEN enables the display of any faults that have occurred in the last 8 manoeuvres, for example interruption of a manoeuvre due to activation
of a photocell or sensitive edge. To check the fault list, proceed as shown in table 19.
Table 19: Fault log list
1. Press and hold [Set] for approx. 3s
2. Release the key [Set] when led L1 starts to flash
3. Press keys [▲] or [▼] to move the flashing led to L8, i.e. the "input led" associated with the
parameter "Fault log"
4. Press and hold [Set] during steps 5 and 6
5. Wait approx. 3s after which the leds corresponding to the manoeuvres subject to faults will light up.
Led L1 indicates the result of the most recent manoeuvre, while led L8 indicates the result of the
eighth manoeuvre. If the led is lit this means that faults have occurred during the manoeuvre; if off this
means that the manoeuvre was completed without faults.
6. Press the keys [▲] and [▼] to select the required manoeuvre:
The corresponding led emits a number of flashes equal to those normally emitted by the flashing light
after a fault (see table 20).
7. Release [Set]
7.7) Diagnostics and indicators
Some devices offer special direct indicators to display the relative operating status or malfunctions..
30
Probable cause and possible remedy
Check that the transmitter batteries are not discharged; replace if necessary.
Check that the transmitter is correctly memorised on the radio receiver.
Ensure correct emission of the radio signal of the transmitter with the following empirical
test: Press a key and place the led against the aerial of a standard radio (the cheaper the
better) switched on and tuned to FM at the frequency of 108.5Mhz or as close to this
value as possible; a slight noise with a scratching pulse noise should be heard.
Ensure that TEN is powered from a 230V mains. Check that fuses F1 and F2 are not
blown; in this case, identify the cause of the fault and then replace with versions of the
same current value and specifications (Figure 30).
Check that the command is effectively received. If the command reaches the SS input
and the led OK emits a double flash to indicate that the command has been received.
Count the number of flashes and check with reference to the data in Table 20.
The selected force may be too low to move the door. Check whether there are any
obstacles, and if necessary select a higher force
GB
Example
SET
3s
SET
L1
or L8
SET
3s
and
SET
25