Ottobock 17LK3 Instructions D'utilisation page 15

► Use the product on only one patient.
► Observe the maintenance recommendations.
NOTICE
Thermal overloading of the product
Damage due to improper thermal treatment
► Do not carry out any heat treatment at a temperature above 300 °C
(570 °F).
NOTICE
Thermal overloading of product components
Loss of function due to improper thermal treatment
► Prior to the thermal treatment of the product, remove all temperature-
critical components (e.g. plastic parts).
NOTICE
Exposure of the product to unsuitable environmental conditions
Damage, brittleness or destruction due to improper handling
► Avoid storage in condensing ambient humidity.
► Avoid contact with abrasive substances (e.g. sand, dust).
► Do not expose the product to temperatures below -10 °C (14 °F) or
above +60 °C (140 °F) (e.g. sauna, excessive sunlight, drying on a
radiator).
5 Processing
5.1 Laminating the orthosis
INFORMATION
The instructions for manufacturing an orthosis with unilateral joint systems
are included in the 646T5=9.1 Technical Information. The laminate struc­
ture described here is a recommendation of Ottobock and can be adjusted
to the needs of the patient.
Ottobock | 15