Alde 3010 Instructions D'installation Et De Montage page 14

9. 7KH WRRO PHQX  IXQFWLRQV
When you are in the tool menu (see section 8), you can use the tools described below. Step between the various tool
¿HOGV E\ SUHVVLQJ WKH XS RU GRZQ DUURZ V\PEROV <RX FDQ DOZD\V OHDYH WKH WRRO PHQX ZLWK WKH 0(18 EXWWRQ NOTE!
)XQFWLRQV PDUNHG ZLWK LQGLFDWH WKDW WKH V\PERO IRU WKH IXQFWLRQ LV GLVSOD\HG RQ WKH FRQWURO SDQHO HYHQ LI WKH
accessory is not installed!
2
5
8
1. Arrow symbols
6WHS EHWZHHQ WKH YDULRXV WRRO ¿HOGV E\
pressing the up or
GRZQ DUURZ V\PEROV <RX FDQ DOZD\V
leave the tool menu with
the MENU button.
2. Clock
The clock must be set if automatic tem-
perature change or automatic start is to be
used. If 12V voltage is lost, the clock will
stop and will no longer be displayed. This
is prevented with an optional mounted bat-
tery backup.
3. Automatic temperature change
This function is used when you want to
programme a timed temperature change,
for example, to have the heating tempera-
ture raised in the morning and lower during
the night.
4. Starting the boiler automatically
This function is used to start the boiler
automatically at a later point of time. With
automatic start, the boiler works for 24
hours and then stops. After that, it repeats
the automatic start once a week; at the
same day and time, as long as the function
is activated. For automatic start to function,
the On/Off button must be set in the OFF
position.
14
3 6
4
7
A
5 10
9
1
11
14
Ext
5. Constant pump operation
With this function, the selected pump is
constantly operating. The function is dis-
connected in the factory setting. This func-
tion limits access to warm water, especially
if not much heating is needed.
6. 3XPS $XWR  9
A
In the Auto mode, the 230V pump oper-
ates, and when 230V is disconnected, the
12V pump starts. In 12V mode, the 12V
pump is used even if 230V is connected.
The Auto function is activated in the factory
setting.
7. *Pump speed
The circulation pump's capacity can be
controlled from the panel. NOTE! A pump
with this control must be installed in
RUGHU WKDW WKLV IXQFWLRQ FDQ EH XVHG
VHH WKH PDQXDO IRU WKH YHKLFOH ERDW RU
building).
8. /3* ERWWOH IXOOHPSW\
This function is used in combination with
the cylinder changeover (DuoComfort
or Secumotion) and indicates if the LPG
bottle is full or empty. This function can
also be used to control defroster heating
of the cylinder changeover using an EisEx
defroster. NOTE! The cylinder changeo-
YHU 'XR&RPIRUW RU 'XR&RQWURO PXVW
EH LQVWDOOHG LQ RUGHU IRU WKLV IXQFWLRQ WR
ZRUN VHH WKH PDQXDO IRU WKH YHKLFOH
boat or building).
12
13
Lan
16
Amp
15