Elvox Vimar SL24.W Guide Rapide Installateur page 26

SL24.W
List of signalling on the display
Signal Description
C1 Contact closed on command C1 input
C2 Contact closed on command C2 input
C3 Contact closed on command C3 input
C4 Contact closed on command C4 input
S1 Contact open on safety device S1 input
S2 Contact open on safety device S2 input
S3 Contact open on safety device S3 input
S4 Contact open on safety device S4 input
FO1 Opening limit switch position reached
FC1 Closing limit switch position reached
OBO Obstacle detected on opening
OBC Obstacle detected on closing
Motor in stop approach force reduction
AF1
interval
MSO1 Mechanical stop reached in opening
MSC1 Mechanical stop reached in closing
Operation with battery
When this message is displayed it is fol-
BATT
lowed by an indication of the battery oper-
ating voltage, e.g. 24.5V
Battery almost flat (indication shown only
BT-
when the gate is stopped)
Battery totally flat (indication shown only
BT--
when the gate is stopped)
Radio command received from saved re-
RX
mote control
Radio command received from unsaved
NX
remote control button
RD Rolling/fixed code decoding off
OAB Gate left open
AT Gate in self-calibration
List of alarms
Alarm Description
XXXX Reset card
Manoeuvre interval since last maintenance
MNP
reached alarm
F0 Error motor not selected
F1 Motor cables inverted error
F3 Reversed limit switch error
F4 Both open limit switch alarm
F5 Opening limit switch malfunction error
F6 Closing limit switch malfunction error
F9 Communication error with expansion card
F10 Error alarm motor not connected
F12 Encoder error alarm
Microswitch undervoltage (check power sup-
F14
ply and outputs)
F15 Safety test 1 failed
F16 Safety test 2 failed
24
F17 Safety test 3 failed
F18 Safety test 4 failed
F19 Manoeuvre length/timeout alarm
F21 Mosfet short alarm
F23 Blocked rotor alarm
F26 5th obstacle in closing alarm
F27 Overcurrent alarm
F29 Radio memory full alarm
F30 Faulty radio memory alarm
F31 Short flashing alarm
F32 Gate open light short alarm
F33 No memory card alarm
F34 FW checksum alarm
F36 Board temperature alarm
Updating Firmware:
The control panel is equipped with a USB port that is used
to update the control panel Firmware or the Wi-Fi EMC.W
communication module Firmware
Caution:
If the firmware updating procedure is not carried out prop-
erly it may damage the control panel or the Wi-Fi com-
munication module, make sure not to interrupt the mains
power supply during the update.
To perform the Firmware Update, consult the instructions
provided with the Firmware
EN