Safety And Liability; Warnings - Weller WQB 3000 Mode D'emploi

11

Safety and liability

No liability is assumed by the manufacturer for other uses that deviate from those specified in the instruction
manual or for unauthorised modifications.
These operating instructions and warnings must be read carefully and kept in an easily visible location near
the soldering unit. Non-compliance with these warnings can lead to accidents, injuries or health problems.
The WELLER BGA Repair System WQB 3000 complies with the EC Conformity Declaration according
to the basic safety requirements in the Directives 89/336/EWG, 73/23/EWG and 89/392/EWG.
12

Warnings

.
1 The power cord should only be inserted in specifically authorised power sockets or adapters.
2. Keep your workstation orderly.
Do not place flammable objects near the hot soldering tool.
3. Take environmental conditions into account.
Do not use the soldering tool in damp or wet conditions.
4. Protect yourself from electrical shock.
Avoid contact with grounded parts such as pipes, heaters, ovens and refrigerators.
5. Keep children away from the unit.
Do not allow other persons to touch the soldering tool and accessories. Keep other persons away from your
workstation.
6. Store the soldering tool carefully.
Unused soldering tools should be stored in a dry, enclosed location beyond the reach of children. Ensure
that unused soldering tools are not connected to power or pressure sources.
7. Do not overload the soldering tool.
Use the soldering tool only with the rated voltage and specified pressure or pressure range.
8. Use the right soldering tool.
Do not use a soldering tool for your work that is weaker than you need. Do not use the soldering tool for
purposes other than those for which it was designed.
9. Wear appropriate work clothes.
Risk of burns from liquid solder. Wear appropriate protective clothing to protect yourself from burns.
10. Protect your eyes.
Wear protective goggles. When working with adhesives, special care should be given to the warnings
provided by the manufacturer of the adhesive. Protect yourself from spatters – liquid solder may result in
burns.
11. Use a soldering fumes exhaust hood.
If there are facilities available to install a soldering fumes exhaust hood, ensure that this equipment is
connected and used properly.
12. Do not use the cable for purposes other than those for which it was designed.
Do not pull on the cable to remove the plug from the socket. Protect the cable from heat, oil and sharp
objects.
36
Cooper Tools GmbH, Carl-Benz-Str. 2, 74354 Besigheim, P.O. Box 1351
Germany, Tel: (07143) 580-0, Fax: (07143) 580108