Special Functions - Weller WQB 3000 Mode D'emploi

The individual program steps must be activated manually by pressing the START key. After the cooling time
has ended, the process must be ended manually by pressing the START key or STOP key.
The four times, as determined, are now in the temporary memory of the program location. The programming
unit will show the Status display.
The process times are saved by pressing the program key twice as described in Section 3.5, Saving and
Loading.
Note: If the times determined with the teach-in mode are too long or if the target temperatures are not
obtained, the corresponding settings (Temp. of top heater, Temp. of bottom heater and Airflow) must
be gradually increased.

3.7 Special functions

The programming unit will show the Status display (it may be necessary to exit the active menu with the Exit
key).
Pressing the Exit key and also pressing the PROGRAM key will call up the special functions menu.
S E C I A L - F U N C T I O N
M E N U E
> O F F S E T
O F F S E T
S T A N D B Y
S T A N D B Y
L O C K M O D E
F A N S P E E D
° C / ° F - D I S P L A Y
The functions are selected using the arrow keys ∧ ∨. To change a value, the value must be confirmed with
the Select key. The arrow > will jump to the value that is currently being set.
The value can be changed with the arrow keys ∧ ∨.
N O Z .
P R E H .
N O Z .
P R E H .
M O D E
30
0 0 0 ° C
0 0 0 ° C
1 0 0 ° C
O F F ° C
O
1 0 0 %
° C
Cooper Tools GmbH, Carl-Benz-Str. 2, 74354 Besigheim, P.O. Box 1351
Germany, Tel: (07143) 580-0, Fax: (07143) 580108
Special Function Menu
Setting special functions