Télécharger Imprimer la page

Vent-Axia Svelte 100B Instructions D'installation Et De Câblage page 3

Publicité

Les langues disponibles

Les langues disponibles

DESCRIPTION
The Lo-Carbon Svelte 100mm fan is an axial extraction fan suitable for domestic
bathrooms and W.C's. The Lo-Carbon Svelte 150mm fan is an axial extraction
fan suitable for domestic kitchens and utility rooms. They are available as wall or
panel mounted models with shutter timer and humidity combinations.
Long life ball bearing DC motor with anti-vibration mounts provides low noise
transmission into plasterboard/panels for silent operation.
The fan can be wall or panel/ceiling mounted.
ACCESSORIES (not supplied)
WALL FITTING KIT
A range of 100mm and 150mm wall kits are
available for installing into most walls using
telescopic liners supplied.
A. INSTALLATION
IMPORTANT: The fan should only be used in conjunction with fixed wiring.
PANEL/CEILING MOUNTING
1.
For panel/ceiling mounting the fan should be installed into a closed duct
system of at least 1.2m long (max 3m) or protected by an exterior air grille
that must comply with the standard requirements of your country to prevent
access to the fans impeller.
2.
Cut a 105mm diameter hole for 100mm fans or a 155mm diameter hole for
150mm fans.
3.
Loosen the screw at the bottom of the grille and remove the front grille.
Mark the screw centres through the holes in the fan back plate. Drill, plug
and screw into position.
4.
Attach ducting as required for the installation.
5.
Wire the fan as described in Section B-Wiring. Adjust any settings as
required (see Section C-Setup).
6.
Replace the grille and tighten the retaining screw.
7.
After installation, ensure impeller rotates freely and the shutters can open.
WALL MOUNTING
1.
For wall mounting either cut a 117mm diameter hole for 100mm fans or a
170mm diameter hole for 150mm fans, through the wall and insert the wall
sleeve. Slope the sleeve slightly downwards away from the fan. Cut to
length and cement both ends into position flush with the wall faces.
2.
Loosen the screw in the bottom of the grille and remove the front grille.
Mark the screw centres through the holes in the fan back plate. Drill, plug
and screw into position. Fix exterior grille into position with the louvres
positioned downwards. (Note:-The grille must comply with the standard
requirements of your country to prevent access to the fans impeller. The
wall kit used in this installation should provide a minimum ducting length of
100mm from the fans back plate to the inside of the external grille).
3.
Wire the fan as described in Section B-Wiring. Adjust any settings as
required (see Section C-Setup).
4.
Replace the grille and tighten the retaining screw.
100
150
3
EN
Stock Reference
White
8000000002
8000000030

Publicité

loading