Advanced Setup - Yamaha RX-V1065 Mode D'emploi

In the advanced setup menu, you can set basic operations
of this unit, such as on and off of a bi-amp connection, or
initialize user settings.
1
Set this unit to standby.
2
While holding down OSTRAIGHT on the
front panel, press KMAIN ZONE ON/OFF.
Keep holding down OSTRAIGHT until
"ADVANCED SETUP" appears on the front panel
display.

ADVANCED SETUP

3
Rotate the NPROGRAM selector to select
the parameter you want to change.
The default setting are marked with "*".
y
• Set values are placed in XXX of the following parameters on an
actual display screen.
SP IMP. -XXX
Choices:
6ΩMIN, 8ΩMIN*
Selects output impedance of this unit according to
connected speakers. When you connect 4-ohm
speakers to the FRONT speaker terminals, set "SP
IMP." to "6ΩMIN.".
REMOTE ID -XXX
Choices:
ID1*, ID2
Sets a remote control ID. When using multiple
Yamaha AV receivers, you can operate them with a
single remote control by setting the receiver IDs to
the same setting.
BI AMP - XXX
Choices:
ON, OFF*
Switches on and off of bi-amp connection of main
speakers. For bi-amp connection, see page 12.
SCENE IR -XXX
Choices:
ON*, OFF
Selects whether or not to transmit the control signals
to an external component connected to the REMOTE
OUT jack on this unit when BD/DVD or CD SCENE
function is selected.
MON.CHK - XXXX
Choices:
YES*, SKIP
Adds upscaling limitation on output signals to a video
monitor connected to this unit via the HDMI OUT
jack.
INIT-XXXXXXXXX
Choices: DSP PARAM, VIDEO, ALL, CANCEL*
Initializes various settings stored in this unit. You can
select an initialization method from the following.
54
En
Advanced setup
DSP PARAM: All parameters of sound field
VIDEO
ALL
CANCEL
4
Press OSTRAIGHT repeatedly to change
the selected parameter setting.
To change other settings, repeat steps 3 and 4.
5
Press KMAIN ZONE ON/OFF to set this
unit to standby.
The settings you made are reflected next time you
turn on this unit.
Updating the firmware
You can check the firmware of this unit and update the
firmware using the USB port on the front panel.
Select the following parameter in step 3 above.
FIRM UPDATE
Updates the firmware of this unit. To update the firmware,
select "FIRM UPDATE" and then press OSTRAIGHT.
Notes
• Do not use this feature unless you need to update the firmware.
• Be sure to read information supplied with updates before updating the
firmware.
VERXXX.XXX.XXX
Displays the firmware of this unit.
Setting a remote control ID
Two IDs are provided for the remote control of this unit. If
another Yamaha amplifier is in the same room, setting a
different remote control ID to this unit prevents unwanted
operation of the other amplifier.
"ID1" is set for both the main unit and remote control by
default. If you have changed the remote control ID, make
sure that you select the same ID for the main unit in the
the advanced setup menu.
1
Press oCODE SET on the remote control
using a pointed object such as the tip of a
ballpoint pen.
nTRANSMIT blinks twice.
2
Press iON SCREEN.
programs
Video conversion settings (resolution/
aspect) in the Setup menu and the GUI
display position
All
Cancellation of initialization