Pitch Shift; Loop Roll; Reverse Loop; Noise - Reloop RMX-80 DIGITAL Mode D'emploi

3.3.6 pItCh ShIft

The Pitch Shift effect manipulates the original signal's tone pitch.
Level Depth:
Not available. The effect always works at a 100%.
Time Encoder:
Steplessly adjusts the pitch. When turning clockwise, the signal's pitch will sound higher. When turning counter-clockwise, the signal's pitch will
sound lower. By pressing the Time Encoder, the effect will be reset.
Time Bar Buttons:
Gradually adjust the pitch. Button 1-1 means no pitch. Buttons with higher values make the signal sound higher, buttons with lower values let the
signal sound lower.

3.3.7 lOOp rOll

The Loop Roll effect repeats the original signal in the selected length and adds it to the original signal.
Level Depth:
Adjusts the ratio between effect signal and original signal.
On the Effect Display -38- this will be shown as Dry & Wet.
0% stands for no effect.
100% stands for maximum effect setting.
Time Encoder:
Steplessly adjusts the loop's length in steps of a millisecond.
If you press and hold the Time Encoder, steps of 50 milliseconds will be carried out.
Time Bar Buttons:
Gradually adjust or trigger the loop.
1-8; 1-4; 1-2; 1-1; 2-1; 4-1.

3.3.8 rEVErSE lOOP

The Reverse Loop effect repeats the original signal in the selected length, reverses it and adds it to the original signal.
Level Depth:
Adjusts the ratio between effect signal and original signal.
On the Effect Display -38- this will be shown as Dry & Wet.
0% stands for no effect.
100% stands for maximum effect setting.
Time Encoder:
Steplessly adjusts the loop's length in steps of a millisecond.
If you press and hold the Time Encoder, steps of 50 milliseconds will be carried out.
Time Bar Buttons:
Gradually adjust or trigger the loop.
1-8; 1-4; 1-2; 1-1; 2-1; 4-1.

3.3.9 nOISe

Adding Signal Noise is a popular effect to emphasize certain passages in a track. The RMX-80's noise can also be modulated via LFO to create
rhythmic effects.
Level Depth:
Adjusts the noises ‚color'.
Time Encoder:
Steplessly adjusts the LFO's speed in steps of a millisecond.
If you press and hold the Time Encoder, steps of 50 milliseconds will be carried out.
Time Bar Buttons:
Gradually adjust the LFO's speed. By pressing button 1-4 the LFO will be deactivated.

3.3.10 BIt CrUSher

The bit crusher effect reduces the original signal's quality which leads to a crispy oldschool sound.
Level Depth:
Adjusts the ratio between effect signal and original signal.
On the Effect Display -38- this will be shown as Dry & Wet.
0% stands for no effect.
100% stands for maximum effect setting.
Time Encoder:
Steplessly reduces the quality from -100 - +100.
Time Bar Buttons:
Gradually reduce the quality -100 - +100.
100; 50; 10; -10; -50; -100.
19