Publicité
Problem
Vehicle runs in low speed, but does
not run in high speed (Please Note:
The vehicle is designed to operate
in low speed only in reverse
When the foot pedal is pressed
only one rear wheel spins
Sometimes the vehicle doesn't
run, but other times it does
When the foot pedal is pressed,
the vehicle won't run without
a push
Loud clacking or grinding
noise from a motor-gearbox
Lights and siren not working
Charger gets warm during use
Battery makes a sizzling or
gurgling noise when charging
If, after reviewing the Problems and Solutions Guide, the vehicle still fails to operate, please contact Power Wheels Consumer Relations.
e Problems and Solutions Guide
Possible Cause
High speed lock-out not disconnected
).
Operation of vehicle in low speed
Loose wire or connector
Motor or electrical switch damage
Loose wire or connector
"Dead Spot" on motor
Broken gears
Improperly installed batteries
Dead batteries
It is normal for some chargers to get warm
during use and is not reason for concern.
It is normal for some batteries to make
noise and swell slightly while charging
and is not reason for concern.
Solution
The vehicle was pre-set to run only in low speed. To allow the
vehicle to run in low and high speed, you must disconnect the
High Speed Lock-Out. Follow the instructions on page 40 to
remove the High Speed Lock-Out screw.
It is possible that only one rear wheel may spin when both rear
wheels are raised off the ground and the vehicle is in low speed.
This does not necessarily indicate a problem. Check for proper
operation of the drive system by raising the rear wheels off the
ground and pressing the foot pedal. If only one rear wheel spins,
carefully press your hand on the spinning wheel to slow it down.
The other rear wheel should begin to spin. If the other rear wheel
does not begin to spin, there may be a problem with the vehicle.
Contact Power Wheels
Check all wires around the motors and all connectors to
make sure they are tight.
Contact Power Wheels
Check all wires around the motors and all connectors to make
sure they are tight.
Contact Power Wheels
Contact Power Wheels
The lights and siren unit requires four "AA" (LR6) alkaline
batteries for operation. Make sure the batteries are properly
installed in the lights and siren unit.
Replace the lights and siren batteries with four, new "AA" (LR6)
alkaline batteries.
No action required. If your charger does not get warm during
use, it does not mean that it is not working properly.
No action required. If your battery does not make noise or
swell slightly during charging, it does not mean that it is not
accepting the charge.
46
®
Consumer Relations.
®
Consumer Relations.
®
Consumer Relations.
®
Consumer Relations.
Publicité
