Operation; Basic Information; Control And Internal Control Unit - Function; Internal Control Unit - LOHBERGER INDALO Manuel D'utilisation Avec Instructions De Montage

3. Slightly lift the lower front panel and remove it to the front. Place
the panel on a soft underlay.
Fig. 3 - Removal of lower front panel.
Work very carefully at disassembly and assembly to not cause
any damage on any cover panel.

9. OPERATION

BASIC INFORMATION

The stove must only be started when fully fitted.
Your pellet stove is exclusively for burning pellets made from
wood of a controlled quality. Non-pelletised solid fuels (straw,
maize, chopped matter etc.) are not permitted. Failure to ad-
here to these guidelines will make all guarantee and warranty
claims null and void and could have a negative effect on the
safety of your stove.
When operated correctly your pellet stove cannot overheat.
Improper operation can however shorten the life expectancy
of the electric stove components (fan, motors and electric
control) and is not permitted.
CONTROL AND INTERNAL CONTROL
UNIT - FUNCTION
Your pellet stove is fitted with a modern programmable micropro-
cessor control. The user can preset the individual stove functions via
the internal control unit (keypad with operating display) fitted at the
top of the right hand stove panel. The control (main board) and the
control board may only be altered by trained specialist dealers or
the service department. Improper handling of these parts leads to
the guarantee and warranty becoming null and void.
34
English

INTERNAL CONTROL UNIT

All settings and functions can be regulated via this unit.
The display is illuminated when touched. After some seconds the
display lighting turns off again.
SIMPLE HEATING OPERATION – EASY MODE –
THE FIRST STEPS
Your stove is in simple heating mode EASY OFF when delivered in
order to ease your start in the world of LOHBERGER pellet stoves.
The heat output of the stove can only be increased or reduced in
5 % increments in this mode. As soon as the stove is connected to
the socket, the standard display EASY OFF appears. The message
„CHECK" appears in the display as soon as your pellet stove is con-
nected to the power supply (even after a power failure). The display
buttons are disabled for approx. 10 seconds as the stove conducts
an initialisation of all components. When „CHECK" disappears from
the display the stove can be started up.
„CHECK" appears in the display whenever
the stove is re-supplied with power.
EASY OFF – INACTIVE STATE
Key Display
EASY OFF
+
EASY 45
-
EASY 35
Description
Standard display for stove switched off in
simple heating mode.
The output can also be regulated between
30% and 100% with the stove switched off
(EASY 30 – EASY 100).
+
Pressing increases output by 5%
-
Pressing decreases output by 5%