ITT VOGEL LM Serie Instructions De Montage page 4

EC Declaration of Conformity
(according to EC Directive on Machinery 2006/42/EC, Annex II A)
The manufacturer,
of the pumps from the standard product line hereby declares:
LM 65-315, LM 80-315, LM 100-160, LM 100-200, LM 100-250, LM 100-315, LM 125-250, LM
125-200, LM 125-315, LM 150-250, LM 150-315
LMN 32-125, LMN 32-160, LMN 32-200, LMN 40-125, LMN 40-160, LMN 40-200, LMN 40-250,
LMN 50-125, LMN 50-160, LMN 50-200, LMN 50-250, LMN 65-125, LMN 65-160, LMN 65-200,
LMN 80-160, LMN 65-160, LMN 65-250, LMN 80-200, LMN 80-250, LMN 80-250
The supplied aggregates meet the relevant regulations of the EC Directive on Machinery, 2006/42/EC
The three-phase electric motor supplied at the same time meets the relevant regulations of Directive
2006/95/EC.
Special technical documentation has been prepared, in accordance with Annex VII A.
If necessary, we can submit the above-listed special technical documentation, in electronic form on a data
storage medium, to the relevant authorities.
The above-listed special documentation can be requested at the following address:
Dipl. Ing. Gerhard Fasching
Abtlg. Research & Development
ITT Austria GmbH
Ernst Vogel-Strasse 2
A-2000 Stockerau, Austria,
Among others, the following harmonised standards have been applied:
EN 809
EN 953
EN ISO 12100, part 1
EN ISO 12100, part 2
EN 60204 part 1
A change to an aggregate which was not approved by us invalidates this declaration. This also applies in
the case that the aggregate is installed in equipment that does not have the declaration of conformity in
accordance with the Directive on Machinery, 2006/42/EC.
In Stockerau, 15 January 2010
(valid only for ITT Austria aggregate supplied in its entirety)
ITT Austria GmbH
Ernst Vogel-Strasse 2
A-2000 Stockerau, Austria
................................................................................................
Robert Salzbauer
Quality Control Department