Maintain For Performance; Storing; Trouble Shooting/Repairs - Max SuperRoofer CN445R2 Manuel D'utilisation Et D'entretien

6. MAINTAIN FOR PERFORMANCE

1 DO NOT FIRE THE NAILER WHEN IT IS EMPTY
2 USE A 3-PIECE AIRSET
Failure to use a 3-piece airset allows the moisture and dirt inside
compressor to pass into the tool directly. This causes rust and
wear, and results in a poor operating performance. The hose
length between airset and tool should be no longer than 5 m since
a longer length results in a reduction in air pressure.
3 USE RECOMMENDED OIL
The velocite or turbine oil should be used to lubricate the tool.
Upon completion of operations, place 2 or 3 drops of oil into the
Air Plug inlet with the jet oiler. (Recommended Oil : ISO VG32)
4 INSPECT AND MAINTAIN DAILY OR BEFORE OPERA-
TION
WARNING
Disconnect air supply and empty the Magazine when inspect-
ing or maintaining the tool.
(1) Drain air line filter and compressor
(2) Keep lubricator filled in air 3-pieces set
(3) Clean filter element of air 3-pieces set
(4) Tighten all screws
(5) Keep Contact Arm moving smoothly

7. STORING

1 When not in use for an extended period, apply a thin coat of
the lubricant to the steel parts to avoid rust.
2 Do not store the tool in a cold weather environment. Keep
the tool in a warm area.
3 When not in use, the tool should be stored in a warm and
dry place. Keep out of reach of children.
4 All quality tools will eventually require servicing or replace-
ment of parts because of wear from the normal use.

8. TROUBLE SHOOTING/REPAIRS

The troubleshooting and/or repairs shall be carried out only by
the MAX CO., LTD. authorised distributors or by other specialists.
Supplement to the operating instruction
According to the European Norm EN 792-13 the regulation is val-
id from 01.01.2001 that all fastener driving tools with contact ac-
tuation must be marked with the symbol "Do not use on
scaffoldings, ladders" and they shall not be used for specific ap-
plication for example:
∗ when changing one driving location to another involves the
use of scaffoldings, stairs, ladders or ladder alike construc-
tions e.g. roof laths,
∗ closing boxes or crates,
∗ fitting transportation safety systems e.g. on vehicles and wag-
ons.
12