Max SuperRoofer CN445R2 Manuel D'utilisation Et D'entretien page 11

MODEL IDENTIFICATION
CONTACT TRIP
The common operating procedure on "Contact Trip" tools is for
the operator to contact the work to actuate the trip mechanism
while keeping the trigger pulled, thus driving a fastener each time
the work is contacted. This will allow rapid fastener placement on
many jobs, such as sheathing, decking and pallet assembly.
All pneumatic tools are subject to recoil when driving fasteners.
The tool may bounce, releasing the trip, and if unintentionally al-
lowed to recontact the work surface with the trigger still actuated
(finger still holding trigger pulled) an unwanted second fastener
will be driven.
CONTACT TRIP
Identified by BLACK TRIGGER.
SEQUENTIAL TRIP (Optional kit)
The Sequential Trip requires the operator to hold the tool against
the work before pulling the Trigger. This makes accurate fastener
placement easier, for instance on framing, toe nailing and crating
applications. The Sequential Trip allows exact fastener location
without the possibility of driving a second fastener on recoil, as
described under "Contact Trip".
The Sequential Trip Tool has a positive safety advantage be-
cause it will not accidentally drive a fastener if the tool is contact-
ed against the work-or anything else-while the operator is holding
the Trigger pulled.
SEQUENTIAL TRIP
Identified by ORANGE TRIGGER.
CONTACT TRIP WITH ANTI-DOUBLE FIRE MECHANISM
(Optional kit)
(US patent 5597106, UK patent 2286790)
The common operating procedure on "Contact Trip" tools is for
the operator to contact the work to actuate the trip mechanism
while keeping the trigger pulled, thus driving a fastener each time
the work is contacted. This will allow rapid fastener placement on
many jobs, such as sheathing, decking and pallet assembly.All
pneumatic tools are subject to recoil when driving fasteners. The
tool may bounce, releasing the trip,and if unintentionally allowed
to recontact the work surface with the trigger still actuated (finger
still holding trigger pulled) an unwanted second fastener will be
driven.
CONTACT TRIP WITH ANTI-DOUBLE FIRE MECHANISM
Identified by RED TRIGGER.
CONTACT FIRE OPERATION
For contact fire operation, hold the Trigger and depress the Con-
tact Arm against the work surface.
SINGLE FIRE OPERATION (ANTI-DOUBLE FIRE MECHA-
NISM)
For single fire operation, depress the Contact Arm against the
work surface and pull the Trigger.
Tool cannot fire a second nail until the Trigger is released and
tool can cycle.
DRIVING FASTENERS
CONTACT FIRE OPERATION (CONTACT TRIP)
For contact fire operation, hold the Trigger and depress the Con-
tact Arm against the work surface.
2
PROCEDURE
1 Hold the Trigger.
2 Depress the Contact Arm.
11
1