Fitting Options; Fitting Optional Edge Guard; Mounting On The Wall - Fronius Acctiva Professional Flash UCN US Instructions De Service

Fitting options

Fitting optional Depending on the device, a special edge guard can be fitted.
edge guard
Important! The edge guard must be fitted if the charger is being mounted on a wall, as
the fitting tools assume that an edge guard is present.
The edge guard must not be fitted if the charger is installed on the floor.
Fitting the edge guard:
1
Important! If the edge guard is to remain fitted to the charger permanently, peel the
cover strips off the adhesive strips.
Mounting on the
wall
(C)
(C)
(D)

Mounting on the wall

1
2
4
2
3
1
Fit the charger to the wall using the optio-
nal wall bracket:
1. Fasten the wall bracket to a suitable
wall surface using dowels, screws and
cut-outs (D)
2. Position charger on wall bracket
- The base of the charger must lie flat
on the wall bracket
Only if the charger is being fitted perma-
nently to the wall bracket.
3. Fasten the charger to the bracket
using the two screws supplied (3)
(diameter 3.5 x 9.5 mm)
NOTE! If fixing to the wall, please
note the weight of the charger.
Only fix to a wall that is suitable to
this purpose.
5
2