Selecting Or Setting Switching Programme - Conrad 61 06 30 Mode D'emploi

f) Selecting or Setting Switching Programme

If this has not happened yet, set the day of the week and time first. Choose between
the heating and cooling mode and set the desired comfort and savings temperature.
The room temperature controller has 10 firmly programmed switching programmes and 10
switching programmes you can programme freely.
At the lower edge of the LC display (on the 24 h timeline printed on the casing), narrow black
dashes are displayed depending on switching programme (one dash per hour).
A black dash means that the comfort temperature is kept by the thermostats in this hour.
If no dah is visible, the thermostat works with the savings temperature (night reduction).
Proceed as follows (also see process plan two pages later):
• Push the button "DAY" repeatedly until the wide black bar at the top of the display is below
the desired weekday (also see chapter 11. a).
• Briefly press the button "PROG" to terminate setting mode.
• Use the button "PROG#" to select the desired switching programme. The switching
programmes "PROG 0" to "PROG 9" are firmly pre-programmed and cannot be changed.
PROG 1
PROG 2
PROG 3
PROG 4
PROG 5

The switching programme "PROG 0" is a special frost-protection programme. The
temperature is firmly set to +7 °C. The display additionally shows the snowflake
icon " ".
42
PROG 6
PROG 7
PROG 8
PROG 9
PROG 0