Operation; Setting The Weekday; Setting The Time; Selectting The Heating Or Cooling Mode - Conrad 61 06 30 Mode D'emploi

11. Operation

a) Setting the Weekday
Push the button "DAY" repeatedly until the black bar at the top of the display is below the
desired weekday.
SUN = Sunday
MON = Monday
TUE = Tuesday
WED = Wednesday
THU = Thursday
FRI = Friday
SAT = Saturday
b) Setting the Time
• To set the hours of the time, push the button "HOUR". Keeping the button down for some time
will quickly adjust the hours display.
• To set the minutes of the time, push the button "MIN". Keeping the button down for some time
will quickly adjust the minutes display.
c) Selecting the Heating or Cooling Mode
• Briefly press the button "MODE" to terminate setting mode.
• Use the button "CL/HT" to select the heating and cooling mode. The display shows the
current operating mode at the bottom left:
Display "HT": Heating mode (for heating operation)
Display "CL": Cooling mode (for operation of the cooling unit/climate system)
• To terminate this setting mode, briefly press "OK".

The setting mode is left automatically if no button is pushed for approx. 10 seconds.
The switch-on delay is also activated in the cooling mode (cannot be switched off).
Observe Chapter 11. i).
In heating mode, the savings temperature must be set lower than the comfort
temperature. This must be set reversed in cooling mode (savings temperature must
be higher than comfort temperature).
39