Assembly & Operation - Conrad 61 06 30 Mode D'emploi

b) Assembly & Operation
• The product should only be used in closed, dry indoor areas; it must not become
damp or wet! There is the risk of a potentially fatal electric shock!
• The product may be operated stationarily installed.
• Operation of the product with two batteries or rechargeable batteries type AA/
mignon is permissible; do not use any other voltage/power supply.
• The switching output on the rear is potential-free (NC and NO contact). It can also
be used to directly control power supply for a heating or cooling device. If work is
required on the mains voltage, it must only be performed by a trained specialist (e.g.
electrician). There is danger to life from electric shock!
Observe the information in Chapter "Technical Data" for maximum contact load
capacity.
• Do not install or operate the product inside of rooms or in bad ambient conditions
where flammable gases, vapours or explosive dust may be or are present! There
is a danger of explosion!
• The product must not be exposed to extreme temperatures, strong vibration or
strong mechanical strain.
• If it can be assumed that safe operation is no longer possible, the device must be
turned off and precautions are to be taken to ensure that it is not used unintentionally.
Then have the product inspected by a specialist.
It can be assumed that safe operation is no longer possible if:
- the product is visibly damaged
- the product does not work or not work properly (smoke or burnt smell, audible
crackling, discolouration of the product or adjacent surfaces)
- the product was stored under unfavourable conditions for an extended period of
time
- if it was subjected to heavy stress during transport
• Should questions arise that are not answered by these operating instructions,
contact us (for contact information, see chapter 1) or another expert.
31