Conrad 61 06 30 Mode D'emploi page 51

Use the frost protection function (chapter 11. g)
• First use the button "DAY" to select the weekday, then briefly push the button "PROG".
• Use the button "PROG#" to select the switching programme "PROG 0"
• Use the button "PROG" to switch to the next day and set the switching programme there, or
the button "OK" to leave setting mode (alternatively wait for 10 seconds without pushing any
button).
Setting the hysteresis (chapter 11. h)
• Briefly push the button "PROG"
• Use the button "1C/2C" to switch between 1 °C and 2 °C
• To leave the setting mode, either briefly push the button "OK" or wait for 10 seconds
Activating/deactivating the switch-on delay (chapter 11. i)
• Briefly push the button "PROG"
• Use the button "DELAY" to switch the switch-on delay ("DLY" in the display) on or off (note:
The switch-on delay cannot be switched off in cooling more to protect the cooling compressor)
• To leave the setting mode, either briefly push the button "OK" or wait for 10 seconds
Reset to the basic settings (chapter 11. j)
• Briefly push the button "RESET". All settings are lost.
51