Maintenance; Vii.1. Essential Maintenance; Vii.2. Battery Replacement - Vortice VORT NRG 600 EC Manuel D'utilisation Et De Mise En Marche

ENGLISH
VII. MAINTENANCE

VII.1. Essential maintenance

System exterior
Check the ducts, flexible hoses and dampers and renew if necessary. Check that all the components connected to the
system are positioned in such a way that vibration is not transmitted to external elements.
System and controls
Every year check the electrical connections.
Filtration
Do not damage the filter element
Classification
Gravimetric
Opacimetric
Components
Filtration

VII.2. Battery replacement

When the low charge alarm appears and the red light illuminates, this indicates that the emergency battery that provides
backup power for the memory and clock is running low. To replace the battery proceed as follows. A condenser protects
the timer and allows it to run for approximately 10 minutes after a power failure. If the battery replacement operation takes
less than 10 minutes, it will not be necessary to reload the programme and the timer will continue to function normally.
The battery type is CR2032
Using a small screwdriver, press in the clips on each side of the battery housing to remove the cover from the base. Hold
the base and remove the cover.
Battery position
Grip the battery and gently pull it upwards to remove it from its housing.
Press the new battery firmly into its support. Note : Be careful to install the battery the right way round to respect the
polarity.
Filtration efficiency
EUROVENT
EU4
EU7
1 MONTH
Supply
(for G4 filters)
Reference
(Water + weak detergent)
G4 Limited (from 1 to 4 times)
M7 (ex F7)
Servicing interval
3 MONTHS
Cleaning
(for G4 filters)
Washing*
NO
6 MONTHS
Cleaning
(for G4 filters)
Aspiration*
Supply*
YES
12 MONTHS
Filter replacement
41