Vortice VORT NRG 600 EC Manuel D'utilisation Et De Mise En Marche page 40

ENGLISH
N°
Title Description
35 Manual Operation in
manual mode
from ...in manual Some functions
36 mode have switched to
to manual mode.
44
48 Low charge Internal battery
error
49 AS temp Check value on
sensor error Ext Al1
50 AR temp Check value on
sensor error Ext Al3
55 VAS pressure Check value on
sensor error Ext UAI1
56 VAR pressure Check value on
sensor error Ext UAI2
59 CO2 sensor Check value on
error Ext AI 4
85 ...in manual Some functions
mode have switched to
manual mode.
86 Carry out the Periodic
servicing inspection
operation
87 ...in manual Some functions
mode have switched to
manual mode.
VI.3. Cancelling the "Servicing required" alarm
For these parameter settings, it is necessary to access the setting menu. This requires authorization to access the
"Function" level.
The procedure is as follows.
Access rights
Enter the code 2222 using the arrow keys then press OK to confirm. Press the left arrow key twice to access the menus.
If you make a mistake, press C twice and repeat the operation.
Settings
A service alarm is generated every 6 months. Enter YES to reset the counter.
40
Type Time Cause
C 5 s Fault for information only (the system has switched to shutdown in PV
or to PG directly on the display (see (7) section V.3.a)
C 5 s In the Manual/Auto menu all options should be set to Auto.
A 5 s The internal battery of the CORRIGO is faulty.
Change the battery so as not lose the program.
See section VII.2
A 5 s The SSG external temperature sensor is out of service
The SSG external temperature sensor is wired
incorrectly (see section V.3.a)
A 5 s The SRG external temperature sensor is out of service
The SRG external temperature sensor is wired
incorrectly (see section V.3.a)
A 5 s The 0-10 V signal is inverted
The fresh air pressure sender is short-circuited
A 5 s The 0-10 V signal is inverted
The recovery air pressure sender is short-circuited
A 5 s The 0-10 V signal is inverted
The CO2 pressure sender is short-circuited
A 5 s In the Manual/Auto menu all options should be set to Auto.
C 5 s See section VI.3
C 5 s In the Manual/Auto menu all options should be set to Auto.
Enter
RAZ filter counter
Enter the password 2222
For the required authorization level :
Current lev. : FUNCTION
Filter alarms
Reset the
Timer : YES