Configuration Mode - GYS FLASH 30.24 HF Mode D'emploi

Masquer les pouces

Table des Matières

Les langues disponibles

Translation of the original instructions

Submenu:

• Languages:

This menu enables to select the language (use the arrows to change the

language).

• Automatic restart:

Automatic restart only works with «Showroom» , «Charge» and «Power

Supply» Mode. This feature enables the charger to restart automatically

and to restart charging after a cut in power.

To activate the «Automatic restart» feature « Configuration | Restart :

ON ».

• Lock Showroom:

To lock the device in Showroom Mode. (To avoid misuse)

To activate the «Lock Showroom» feature « Configuration | Lock

Showroom : Y ».

Shortcut to Lock Showroom:

The «Lock Showroom» feature can be activated without accessing the configuration menu.

• Turn off the device (main switch in OFF position)

• Push the MODE key

• Turn on the switch, while the MODE key is still pressed. Within 3s the display will show «GYS-

FLASH 30.24 HF Vx.x»

• Hold the MODE key until the screen displays «lock showroom: Y»

• Charge type:

It is possible to choose the type of charge wanted:

- Automotive charge (automo.) to charge starter batteries.

- Traction charge (traction) to charge traction batteries.

• Cables check:

This mode must be used each time the cables are changed. This charger can be fitted with cables up to 2x8m

in 16mm².

OK : The calibration was successful.

FAIL : A problem occurred during the calibration. In this case, the calibration is reset to the factory setting.

Check that the cables are in good condition and properly put in short-circuit and repeat the procedure.

• Advanced Menu (code 1-9-6-4) :

This menu is intended for expert user only.

To access this menu, enter in the code («Select» key to change the digit selection and «Start/Stop» key to confirm

the code).

For more details, see next page.

• Reset Memory (code 1-9-6-4) :

This menu is intented to factory reset the charger settings by

entering the code above. Any personal parameters are deleted.

GYSFLASH 30.24 HF