Configuration Mode - GYS FLASH 50.24 HF Mode D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Submenu:

• Languages:

This menu enables to select the language (use the arrows to change the

language).

• Automatic restart:

Automatic restart only works with «Showroom» , «Charge» and «Power

Supply» Mode. This feature enables the charger to restart automatically

and to restart charging after a cut in power.

To activate the «Automatic restart» feature « Configuration | Restart :

ON ».

• Lock Showroom:

lock

the

device

To activate the «Lock Showroom» feature « Configuration | Lock

Showroom : Y ».

Shortcut to Lock Showroom:

The «Lock Showroom» feature can be activated without accessing the configuration menu.

• Turn off the device (main switch in OFF position)

• Push the MODE key

• Turn on the switch, while the MODE key is still pressed. Within 3s the display will show «GYS-

FLASH 50.24 HF Vx.x»

• Hold the MODE key until the screen displays «lock showroom: Y»

• Charge type:

It is possible to choose the type of charge wanted:

- Automotive charge (automo.) to charge starter batteries.

- Traction charge (traction) to charge traction batteries.

• Cables check:

This mode must be used each time the cables are changed. This charger can be fitted with cables up to 2x8m

in 16mm².

OK : The calibration was successful.

FAIL : A problem occurred during the calibration. In this case, the calibration is reset to the factory setting.

Check that the cables are in good condition and properly put in short-circuit and repeat the procedure.

• Advanced Menu (code 1-9-6-4) :

This menu is intended for expert user only.

To access this menu, enter in the code («Select» key to change the digit selection and «Start/Stop» key to confirm

the code).

For more details, see next page.

• Reset Memory (code 1-9-6-4) :

This menu is intented to factory reset the charger settings by

entering the code above. Any personal parameters are deleted.

GYSFLASH 50.24 HF

Showroom

Mode

(To

avoid

misuse).

RESET MEMORY

Error Code