POWER SUPPLY MODE CONFIGURATION
POWER SUPPLY
U=13.5V
POWER SUPPLY
U=19.6V
POWER SUPPLY
U=19.6V
NOTE: Unlike other modes, Power Supply mode, the charger does not compensate cables voltage drop. In this case, the voltage
displayed on the screen corresponds to the output voltage of the charger (not the voltage on the clamps).
CONFIGURATION MENU
Access to configuration menu :
To browse in the sub menu press the
«Select» key :
Sub menu :
• Languages :
This menu enables to select the language (use the arrows to change the
language).
• Automatic restart :
Automatic restart only works with «Showroom», «Charge» and «Power
Supply» mode. This feature enables charger to restart automatically and
to restart charging after a cut in power. To activate the «Automatic res-
tart» feature « Configuration | Restart : ON ».
• Lock Showroom :
To
lock
the
device
To activate the «Lock Showroom» feature « Configuration | Lock
Showroom : Y ».
GYSFLASH 50.12 HF
I<50A
2.0V
2.1V
...
I<50A
30.0V
2A
3A
...
I<35A
50A
3 sec - Mode
MODE
languages > restart > lock showroom > cable check > ADVANCED
SELECT
MENU > Reset Memory
in
Showroom
Mode
Start up :
• Push the START/STOP key to start the mode.
• During use, the current consumed and the instan-
taneous voltage are displayed.
POWER SUPPLY START UP
POWER SUPPLY
U=19.6V
(to
avoid
misuse).
POWER SUPPLY
I<50A
U=19.6V
CONFIGURATION MODE
Nederlands
SETTINGS
English
Portugues
ON
SETTINGS
restart:
OFF
OFF
Y (yes)
SETTINGS
lock showroom:
N
N (no)
SETTINGS
Cables Testing:
Cables testing
Press START
SETTINGS
Advanced menu
Advanced Menu:
Press START
SETTINGS
Reset Memory
Reset Memory:
Press START
EN
I=10A
English
Francais
Deutsch
Espanol
Italiano
Russian
...
17