Installation Preparation; If The Refrigerator Can Not Pass Through A Door; During Installation, Follow These Steps - BORETTI BIG-K Notice D'emploi

Installation Preparation

en
Check if the refrigerator can pass a doorway or enter a door first.
Dimensions (including Door Handles)
(Width*Depth*Height)
Find a suitable place to install
Sufficient space from refrigerator back to the wall for free
air ventilation
Once the installation place is ready follow the installation instructions.
If surround temperature of refrigerator is low (below 5 ), foods can be frozen or the refrigerator can work in
abnormal way.
903mm 734.5mm 1790mm
Avoid direct sunlight.
16

If the refrigerator can not pass through a door

during installation, follow these steps.

Removing Freezer Door
1 Remove the bottom cover first. 2 Unscrew top hinge cover with a
Pull out the left collar of the coupling screw driver.
first, then hold the coupling and pull out
the left water tube.
!
4 Lift up the front of hinge to remove. 5 Be careful not to damage the water line
( After the hinge is removed the door when removing the door.
can fall down forward. Be careful !)
Removing Refrigerator Door
1 Unscrew top hinge cover with a 2 Turn top hinge fastener
screw driver. counterclockwise 3~4 times.
Insert a thin screw driver into the Disconnect harness wires.
side groove of the cover to remove.
4 Lift the door straight up to remove.
Remove front bottom cover first, if it is attached.
3 Turn top hinge fastener
counterclockwise 3~4 times.
Disconnect the harness wires.
3 Lift up the front of hinge to remove.
(After the hinge is removed the
door can fall down forward. Be
careful !)
!
17
en