Preparation - BORETTI M-System MKR-88 Notice D'emploi

Refrigerator Diagram-- Preparation
1.Shelves
2.Vegetable and fruit tray
3.Temperature Controller
4.Egg tray
5.Bottle racks
This diagram may vary slightly with the layout of the refrigerator you have
just purchased due to technical improvements.

Preparation

Unpacking
Remove all packing materials.
Check attachments and materials
Checking should be conducted with reference to the Packing List. Contact the local
distributor if discrepancies are found.
Ensure proper location of the refrigerator.
Make sure the refrigerator is kept upright during handling.If an inclination is required,
*
it should not exceed 45 degrees. Otherwise the appliance may get damagedresulting
not only in compromised refrigeration performance.
To avoid product damage or personal injury, the refrigerator should be unpacked
*
by two persons after it is located in a previously selected position.
* Before installation,make sure the refrigerator has no visible exterior damage.
When handling the refrigerator, do not lift it by holding the worktop, to prevent
*
any damage to the refrigerator.
Do not start up a refrigerator that is damaged.
*
Clean the refrigerator before use.
(See the following section "Cleaning")
Idle time
After the refrigerator has been sited and cleaned, let it stand for more than 30 minutes
before connecting the power source
3