Güde GHF 800 Traduction Du Mode D'emploi D'origine page 9

takes place during a vocational training to achieve the skill
and under supervision through a trainer.
Training
The use of the product requires only a corresponding training
through a skilled staff or on the basis of the operating manual.
A special training is not necessary.
Operation
Make sure the Laminate cutter is positioned properly and
cannot be tipped over.
Instructions step by step
1. Mark a line in the place where the workpiece is to be cut.
2. Insert the workpiece in the tile cutter and place the
cutting edge on the line with the lever being partially
pressed down.
3. Press the lever down with constant pressure.
4. Place the workpiece cleanly to the stop and cut in the
required place at rectangular cuts!
Maintenance and protection
All service and repair works can be done by skilled
professionals only.
- Regularly remove dust and cuttings from the appliance.
- Grease the mechanical parts by suitable lubricant
Knife grinding:
The cutting wheel of the tile cutter is made of wear-free
material. Due to its special shape, the cutting blade must
not be ground or sharpened.
Malfunction – reasons - elimination
Malfunction Possible reasons
The handle cannot Look for bits of
be moved neither stones on the
up nor down. splitter.
Workpiece is not There can be small
standing on bits of stones on
upholstered the upholstered
supports evenly. supports.
Elimination
Remove the bits of
stones using a
brush or by
blowing.
Clean up the
upholstered
supports and lower
part of the splitter.
9