Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7.2.1
Cutting
▶ When cutting, apply moderate feed pressure and do not tilt the product or the cutting disc to either side
(hold at approx. 90° to the cutting plane).
For best results when cutting profiles and small-section rectangular tubes, start cutting at the
smallest cross section.
7.2.2
Rough grinding
▶ Move the product to and fro while maintaining a 5° to 30° angle of attack and applying moderate pressure.
◁ This will avoid overheating and discoloration of the workpiece and help ensure an even surface finish.
7.3
Switching off
▶ Release the on/off switch.
◁ The safety lock jumps back automatically into the locked position and the motor stops.
8
Care and maintenance
WARNING
Danger of electric shock! Carrying out care and maintenance while the supply cord is connected to the
power outlet presents a risk of serious injuries including burns.
▶ Always unplug the supply cord before carrying out all care and maintenance tasks.
Care
•
Carefully remove stubborn dirt from the tool.
•
Clean the air vents carefully with a dry brush.
•
Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
they can attack the plastic parts.
Maintenance
WARNING
Danger of electric shock! Improper repairs to electrical components may lead to serious injuries including
burns.
▶ Repairs to the electrical section of the tool or appliance may be carried out only by trained electrical
specialists.
•
At regular intervals, check all visible parts and the controls for signs of damage and make sure that they
all function correctly.
•
Do not operate the power tool if signs of damage are found or if parts malfunction. Have damage repaired
immediately by Hilti Service.
•
After cleaning and maintenance, refit all guards or protective devices and check that they function
correctly.
8.1
Checks after care and maintenance work
▶ After carrying out care and maintenance, check that all protective and safety devices are fitted and that
they function faultlessly.
9
Transport and storage
•
Do not transport electric tools with accessory tools fitted.
•
Always unplug the supply cord before storing an electric tool or appliance.
•
Store tools and appliances in a dry place where they cannot be accessed by children or unauthorized
persons.
•
Check electric tools or appliances for damage after long periods of transport or storage.
10
Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
2143517
*2143517*
Printed: 20.04.2018 | Doc-Nr: PUB / 5300553 / 000 / 01
English
13
Publicité
Table des Matières
