Capital Safety DBI SALA 8561233 Manuel page 12

6.0 MAINTENANCE - SERVICING - STORAGE
6.1 Clean the Side Entry System with a mild soap detergent solution. Excessive build-up of dirt, tar, etc. may
prevent the system from working properly. If you have any questions concerning the condition of your Side
Entry System or have any doubt about putting it into service, contact Capital Safety immediately. Refer to
manufacturer's instruction for maintenance, servicing, and storage procedures of subsystem components.
6.2 Additional maintenance and servicing procedures (i.e. replacement parts) must be completed by a factory
authorized service center. Authorization must be in writing.
7.0 TERMINOLOGY
AUTHORIZED PERSON: A person assigned by the employer to perform duties at a location where
the person will be exposed to a fall hazard (otherwise referred to as "user" for the purpose of these
instructions).
RESCUER: Person or persons other than the rescue subject acting to perform an assisted rescue by
operation of a rescue system.
CERTIFIED ANCHORAGE: An anchorage for fall arrest, positioning, restraint, or rescue systems
that a qualified person certifies to be capable of supporting the potential fall forces that could be
encountered during a fall or that meet the criteria for a certified anchorage prescribed in this standard.
QUALIFIED PERSON: A person with a recognized degree or professional certificate and with extensive
knowledge, training, and experience in the fall protection and rescue field who is capable of designing,
analyzing, evaluating and specifying fall protection and rescue systems to the extent required by this
standard.
COMPETENT PERSON: One who is capable of identifying existing and predictable hazards in the
surroundings or working conditions which are unsanitary, hazardous, or dangerous to employees, and who
has authorization to take prompt corrective measures to eliminate them.
8.0 LABELING
8.1 Labels shown in Figure 9 should be securely attached to the Side Entry System and fully legible.
12