Infant Car Seat Installation; Britax/Bob Infant Car Seat Installation (All Models) - BOB DUALLIE Instructions

INFANT CAR SEAT
INSTALLATION
BRITAx/BOB INFANT CAR
SEAT INSTALLATION (ALL
MODELS)
Failure to properly secure
Restraint Belt and to
properly install Infant Car
Seat on Infant Car Seat
Adapter may result in
accident, injury or death.
1. Prepare Stroller
Set parking brake, rotate canopy
towards handlebar, place Restraint Belt
ends to the sides of stroller seat (see
stroller owner's manual if necessary).
2. Align Infant Car Seat
Place Infant Car Seat"rear facing",
directly centered on top of ICSA, align
ICS Adapters on Infant Car Seat with
the Click & Go Receivers on ICSA.
3. Verify Infant Car Seat is Latched
Properly
Push Infant Car Seat straight down
onto ICSA until the adapters on each
side lock into the receivers on ICSA.
CLICK
4. Verify Infant Car Seat is
Securely Attached
Pull up to ensure the Infant Car
Seat is secure.
5. Secure Restraint Belt
Proceed to section titled "Securing
Restraint Belt" (pg.14).
CLICK
12
P637500A