once you have used up all the cleaning liquid out of the
fresh water tank, empty the waste water tank, so that the
float cannot interrupt the cleaning procedure due to the waste
water tank being full .
However, you can note the sucking up procedure being
interrupted, by hearing the motor running at a much higher
speed .
Switch off appliance, disconnect the mains plug and empty the
waste water tank .
hard floor cleaning
Fold down the hard floor adapter
over the carpet spraying nozzle
and slide it into position until it
locks .
By using this system you can clean
and dry your hard floors such as
tiles, stone floors and PVC in one
go .
See "carpet cleaning" for
procedure.
We recommend THOMAS ProFloor cleaning concentrate for
hard floor cleaning .
Maintenance cleaning of even floor coverings such as
linoleum, PVC, tiles, polished stone floors and lami-
nate floors with the microfibre pad
– General instructions:
Proper care of floors is an essential component
under our terms of guarantee!
To be observed without fail are the special care
instructions of the manufacturer of the floor
coverings.
The surface protection finish can be damaged or destroyed if using
aggressive universal cleaners .
Maintenance cleaning is to be carried out by dust vacuuming or by
wiping with moist cloth (atomised spray) .
Atomised spray means: The floor must be completely dry after 3-5
minutes . only use this method on laminate floors if recommended by
manufacturer .
Wash the microfibre pad before using it for the first time to remove
any possible residue given as a result of the production process .
We recommend THOMAS ProFloor cleaning concentrate for
maintenance cleaning of even floor coverings such as linoleum, PVC,
tiles, polished stone floors and laminate floors .
Dismantling/assembling:
1.
20
2.
6.
2.
3.
To remove the fold back hard floor adapter from the carpet spraying
nozzle, pull the slide upwards and then press the red bolt on the
nozzle towards the inside . Release the hard floor adapter from its
hinge and remove .
Proceed in the reverse order to fit the wiping adapter .
The microfibre pad is to be fixed onto the strip so that the suction
channel in the nozzle is or remains open .
Window cleaning
Fit the wiping adapter to the carpet spray nozzle . To assemble, see
maintenance cleaning instructions for even floors .
1.
The microfibre pad for window cleaning (grey) is to be fixed onto
the strip .
You can clean and dry your windows and glass surfaces in one go
by this method .
Procedure see "carpet cleaning".
Upholstery cleaning
Use the upholstery spraying nozzle to clean upholstered furniture, car
seats, etc . Slide this nozzle onto the grip . Connect the spraying hose
to the shut-off valve .
If cleaning upholstery make sure that not too much liquid is applied
because this will lead to a longer drying time depending on the sub-
structure .
Flow rate control on the hand grip .
See "carpet cleaning" for procedure.
We recommend THOMAS ProTex cleaning concentrate for
upholstery cleaning .
5.
4.
Set the spraying volume regula-
tion (25) to "min" . Start spraying
operation for 2–3 seconds and
moisturise microfibre pad (white) .
Drenching the surface has to be
avoided because it may be that
the edge areas of parquet or
floor elements are not adequate-
ly protected against moisture .