PrimAster KZS1500 Traduction Des Instructions D'origine page 25

– Do not use any electric tool on which the
switch cannot be switched on and off.
21 ATTENTION!
– Exercise elevated caution for double mitre
cuts.
22 ATTENTION!
– The use of other insertion tools and other
accessories can entail a risk of injury.
23 Have your electric tool repaired by a qualified
electrician
– This electric tool conforms to the applicable
safety regulations. Repairs may only be per-
formed by an electrician using original spare
parts. Otherwise accidents can occur.
Additional safety instructions
1 Safety precautions
– Warning! Do not use damaged or deformed
saw blades.
– Replace a worn table insert.
– Only use saw blades recommended by the
manufacturer which conform to EN 847-1.
– Make sure that a suitable saw blade for the
material to be cut is selected.
– Wear suitable personal protective equipment.
This includes:
– Hearing protection to avoid the risk of
becoming hearing impaired,
– Respiratory protection to avoid the risk of
inhaling harmful dust,
– Wear gloves when handling saw blades
and rough materials. Carry saw blades in a
container whenever practical.
– Wear goggles. Sparks generated during
work or splinters, chippings and dust
coming from the device can lead to loss of
eyesight.
– Connect a dust collecting device to the elec-
tric tool when sawing wood. The emission
of dust is influenced, among other things,
by the type of material to be processed, the
significance of local separation (collection or
source) and the correct setting of the hood/
guide plates/guides.
– Do not use saw blades made of high-speed
alloy steel (HSS steel).
2 Maintenance and repair
– Pull out the mains plug for any adjustment or
repair tasks.
– The generation of noise is influenced by
various factors, including the characteristics
of saw blades, condition of saw blade and
electric tool. Use saw blades which were
designed for reduced noise development,
insofar as possible.
Maintain the electric tool and tool attach-
ments regularly and if necessary, initiate
repairs in order to reduce noise.
– Report faults on the electric tool, protective
devices or the tool attachment to the person
responsible for safety as soon as they are
discovered.
3 Safe work
- Make sure that a suitable saw blade for the
material to be cut is selected.
- Never use the machine to cut other materials
as specified.
- To transport the machine follow the procedure
of point 9.
When transporting the electric tool, only use
the transport devices. Never use the protective
devices for handling or transport.
- Operate the machine only if the protective
devices are functional, in good condition and in
the correct position.
- The floor around the machine must be level,
clean and free of loose particles, such as chips
and cutting residues.
- Only use saw blades for which the maximum
permissible speed is not lower than the maxi-
mum spindle speed of the machine and which
are suitable for the material to be cut.
- Be sure to only use spacers and spindle rings
specified by the manufacturer as suitable for
the intended purpose.
- Attention! Do not replace the laser by a differ-
ent type.
Repairs may only be carried out by the manu-
facturer or an authorized representative.
- Do not remove any cutting residues or other
parts of workpieces from the cutting zone while
the machine is running and the saw unit is not
at rest.
Warning! This electric tool generates an electro-
magnetic field during operation. This field can impair
active or passive medical implants under certain
conditions. In order to prevent the risk of serious or
deadly injuries, we recommend that persons with
medical implants consult with their physician and the
manufacturer of the medical implant prior to operat-
ing the electric tool.
Safety instructions for the handling of saw
blades
1 Only use insertion tools if you have mastered their
use.
2 Observe the maximum speed. The maximum
speed specified on the insertion tool may not
be exceeded. If specified, observe the speed
range.
GB | 25