Pentair Blueflo Guide D'installation page 8

MAINTENANCE
Regular maintenance, cleaning and inspection of the pumps is extremely important. This will reduce problems and increase
operating safety and reliability.
MAINTENTANCE
Maintenance of the product should be carried out only by specially qualified personnel.
Before starting the pump after extended non-use or when restarting in the spring, it is advisable to turn the motor shaft, with
the pump switched off and the pump full of water, by means of the motor fan using a screwdriver. This will free the shaft seal
and make starting the pump easier.
REPLACEMENT PARTS
Replacement parts must conform to the technical requirements specified by the manufacturer. This is always guaranteed
when using original replacement parts. We only offer a guarantee for original replacement parts supplied by us. We accept
no liability or guarantee in the event of damage caused by the use of unauthorized replacement parts or accessories.
TROUBLESHOOTING
PUMP WILL NOT PRIME
MOTOR DOES NOT OPERATE
LOW FLOW - HIGH FILTER PRESSURE
LOW FLOW - LOW FILTER PRESSURE
NOISY PUMP
HEATING OF MOTOR
LOGIC SAFE enabled
www.pentairpooleurope.com
Insufficient water in pump casing
Primary pump not providing water
Incoming valve closed
Air leak in suction line
Power is off
Circuit breaker has tripped
Pump is off by time controlled unit
Motor connection is incorrect
Impeller is blocked by debris
Filter is dirty
Restriction in return line
Inlet plumbing is blocked
Impeller is blocked by debris
Air leak in suction line
Motor rotation is incorrect
Air leak in suction line
Debris in plumbing lines or pump housing
Diameter of suction line is too small
Incorrect pump installation
Cavitation (restriction of water)
Insufficient ventilation of motor
Size of wiring is too small
Check chapter 'Logic Safe' for resolution and safe restart