Napoleon HIGH COUNTRY NZ3000 Instructions D'installation Et D'opération page 30

Masquer les pouces Voir aussi pour HIGH COUNTRY NZ3000:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

30
One black wire
EN
- connects to power "L2"
(neutral lead).
One green wire
- connects to ground.
One white wire
- connects to the fan-
speed control, rheostat, or
wall switch,or thermostat.
VENT CONNECTION
D.
Connect the 6"(152.4mm) liner to the 6"(152.4mm) appliance collar and blower collars. Secure using
3 screws on each end and seal with caulking. Liner stretches to a maximum of 10'(3m).
GRILL AND FILTER INSTALLATION
E.
Insert the fi lter into the grill. Foam gasket (
blower housing is recommended, but not supplied. The blower fi lter is washable. The bottom lip of
the grill latches over the bottom lip of the housing. Use two screws to secure the top of the grill to the
facing.
NOTE: FOR COMPLETE INSTALLATION INSTRUCTIONS REFER TO THE BLOWER KIT.
W415-0711 / D / 05.09.13
BY-PASS
(SUMMER)
SWITCH
NOT SUPPLIED
THERMODISC
FAN-SPEED CONTROL
(RHEOSTAT {VARIABLE SPEED SWITCH})
or WALL SWITCH or THERMOSTAT
INSTALL THE KB35 AND
BY-PASS SWITCHES IN A
CONVENIENT LOCATION
NOT SUPPLIED
GRILL
1
/
"(12.7mm) weather stripping) between the grill and
2
PRESSURE
SWITCH
L1
G
L2
FAN
FILTER
ALLOW FOR
THICKNESS
OF FINISHING
MATERIAL

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

High country nz3000h-1

Table des Matières