Technical Data; Trouble Shooting; Before Calling For Service - Olimpia splendid AQUARIA S1 20-24 P Instructions Pour L'installation, L'emploi Et L'entretien

6 - TECHNICAL DATA

Consult the data plate applied to the product (Fig. 2) for the technical data listed below:
- Supply voltage
- Absorbed power
- Insulation class
- Appliance weight

7 - TROUBLE SHOOTING

BEFORE CALLING FOR SERVICE

Before contacting professional service, consult this list.
This list includes common occurrences that are not the result of a defect in workmanship or materials.
Low temperature operation with Auto Defrost function
The appliance is equipped with an automatic defrost function (indicated by the specific led "L4" switching
on) which, thanks to opportunely timed intervals and by checking room temperature, adjust the machine
operation.
PROBLEM
The unit doesn't operate.
The dehumidifying
function doesn't work
or the unit turn on / off
frequently.
Operation is noisy.
The display shows E1.
The keys of the control
panel do not work.
EN - 22
POSSIBLE CAUSES
The supply cord is disconnected.
The tank full warning led is turned on
(tank full or not correctly positioned).
Room temperature exceeding the
maximum work conditions of the
appliance.
Compressor protection is active (the
unit cannot work).
Filter is clogged.
Filter damaged.
Door or window open.
The air inlet/outlet grilles are clogged.
The room is too large or there's too
much humidity.
The unit is tilted or unsteady.
Filter is clogged.
Filter damaged.
Temperature sensor faulty.
Mode "Child Lock" active.
ADVISED SOLUTIONS
Insert the plug in the power socket and
make sure there's electrical voltage.
Drain water tank and reset your setting,
or replace the water tank to right place.
Self-Protection designed to protect
the unit. Can not work under such
temperature.
Clean the filter.
Replace the filter.
Close the door and/or the window.
Remove the obstruction or clean the air
inlet/outlet grilles.
If possible, remove or reduce the level
of humidity.
Place the appliance on an even, solid
surface (less vibration).
Clean the filter.
Replace the filter.
Call the service center.
Deactivate the mode "Child Lock".