B - Continuous Water Unloading; Blackout; Maintenance And Cleaning; Cleaning - Olimpia splendid AQUARIA S1 20-24 P Instructions Pour L'installation, L'emploi Et L'entretien

• Correctly reposition the tank (7) in the appliance body, otherwise the led (L9) remains turned on and
the appliance doesn't work.

3.4.b - Continuous water unloading

• If desired, it is possible to connect the supplied hose (14) to the connection (13) to continuously drain
water collected by dehumidification.
• Switch off the appliance and disconnect the plug from the power socket.
• Connect the rubber hose (14) with an internal diameter of 10mm to the connection (13) (Fig. 9).
• It is advised to fix the hose (14) to the connection (13) using a clamp (not supplied).
• Correctly reposition the tank (7) in the appliance body making the hose (14) pass in specific seat
located in the tank (7). If this operation is not completed, the led (L9) remains on and the appliance
doesn't work.
Make sure the rubber hose (14) doesn't exceed the exhaust joint height,
otherwise water will remain in the appliance and could cause a malfunction,
damage it and/or cause dangerous work conditions.
During operation with continuous unloading, do not remove the water tank.
Possible problems caused by the external water drain are not detected by
the full tank alarm. An efficient supervision is necessary in order to prevent
malfunctions, damages to the appliance and/or dangerous work conditions.

3.5 - BLACKOUT

In case of blackout, the appliance restarts to work in the previously selected conditions when power is
restored.

4 - MAINTENANCE AND CLEANING

Before performing any cleaning or maintenance
intervention on the appliance, disconnect the plug
from the power socket and wait for the fan to stop
completely.

4.1 - CLEANING

4.1.a - Cleaning the appliance

• Use a dry cloth to clean the appliance.
• If the appliance is very dirty, it is possible to use a cloth dampened with warm water (max 50°C) and
a mild detergent to clean its external parts. Dry with a dry cloth.
Make sure the appliance is completely dry before reconnecting the plug to
the power socket.
Do not use a chemically treated or antistatic cloth to clean the appliance. Do
not use petrol, solvents, polishing pastes or similar. These products could
break or deform the plastic surface.
EN - 20